WELDING FOR COATED ELECTRODE 0,35 MM 2 – MATERIAL USED the experimental procedure Mechanics was carried through in the Laboratory of Manufacture and for the accomplishment of the following equipment had been the same used: Material: Steel part 1020 and metalo Figure 1: Part/metalo Equipment: Weld machine 220v, 85A and 430C? Mark: Soldac 430C? Manufacturer: White Martins and Morsa of group of benches: 4 IN Appear 2: Weld machine Figure 3: Morsa Consumable: Electrode AWS and 6013? steel 0,35mm and brush Figure 4: Electrode Appears 5: Steel brush Tools: Pico Appears 6: Pico 2,1 – DESCRIPTION OF the PROCEDURE 1 step: Clothes of the Equipment of Individual Protection (Glove and apron in scrap and mask of weld with filter lenses). 2 step: To bind the weld machine (command key). 3 step: Adjustment of the amperage for 80A (1 step). 4 step: To execute test in two weld laces in a preparation material, being certifyd that the machine is adjusted correctly. 5 step: To fix the part (steel 1020) in morsa lined up with the metalo that will be made to the union, to stop with weld nugget the four sides of the part, with this the same one keeps the alignment.

6 step: To effect the root of weld constructing one filete I finish with the machine in the regulation of 80. 7 step: To invert the position of the part and to carry through the root. 8 step: To remove the slag with ‘ ‘ Pico’ ‘ of the two sides. 9 step: To pass brush to remove the intent slag of the two sides. 10 step: Adjustment of the amperage for 120A for finishing. 11 step: To effect 2 step (finishing). 12 step: To invert the position of the part and to carry through 2 step (finishing).